esg wrote:1- Can't be done in FS9 to my knowledge
2- We won't be converting the VC for FSX any time soon
3- Buggy ECAM? Buggy E/WD? What?
4- Why don't you try your hand it?
I'm sorry if my suggestion or comment was offensive
You are the expert here so I won't say much more than some friendly suggestions because I'm no expert in anything. And to keep things short, I will reply in bullet points too
.
So 1- That's ok. If it's a limitation of the FS, it's out of your hands too. You can't do much about it and I can understand that.
2- I don't mind if you don't convert the VC for FSX as my VC is working in FSX perfectly without anything wrong (apart from a few small.. shall we call them glitches? stated below) But what I thought was if the gauge could be done in FSX, can a gauge file (container? .CAB or .GAU) be released as a standalone PA gauge?
3-This picture here:
There is a black rectangle on the bottom right of the ECAM, only the numbers remain there. It's not much of an issue but it flickers so sometimes it could be annoying. I'm just reporting this flicker but I'm not saying anything like "FIX IT!" because I hardly look at the FF anyway :? .
This is also something I have noticed:
The numbers are displaced when I switch to other pages of the ECAM but of course I can just look a few pixels down at the GW when I decide whether I'm over the MLW or not, so like I said, I seriously don't mind if you don't change it.
I only said the E/WD was buggy because when the VC was publicly about 3 days old, it looked like nobody could get the E/WD working in the VC, and I'm sorry for that.
4-Believe me, I have looked really hard on the internet about gauges but nothing even close to a camera gauge. Can you point me a direction which could get me started?
Thanks PA team and I have always thought the Project Airbuses were the best partly because of the extensive support given on these forums.
)