I never had this issue !! and nobody report to me this phenomenon !!! very strange !!!The320Pilot wrote:Francois, I think I had an issue with the A318. After landing and vacating the runway on my first test flight, look at the MCP: the HDG numbers are missing. Also, the V/S display is missing two zeroes, although when I took off all of them were present (as far as I remember); they disappeared during descent. I was initially descending in managed mode but then I used manual V/S and that's when the zeroes were gone.
When a bug appears during a flight, Think to save you flight (names your savegame file ICAO to ICAO); When you save a flight, FD-FMC create a backup file of its data and flight setting in a CSV file called like the flight plan file with ".....FMS dataSave.csv" at the end of the name.
This file is saved in the Flight plan files folder (C:\Documents and Settings\Username\My documents\Flight Simulator X Files) depend of your Windows version....
exemple : "IFR Entzheim to Marseille Provence.PLN FMS dataSave.csv"
You can open this file with a text editor or Excel, and post here the content.
This is a blackbox file :
"Aircraft type:","Airbus","A318 IAE"
"Save Flight Plan","1."
"Departure Aircraft Position","1.","05"
"Flight Plan File",,"C:\\Documents and Settings\\Fdd\Mes documents\\Fichiers Flight Simulator X\\IFR Entzheim to Marseille Provence.PLN"
"Departure Airport : ","LFST"
"Departure Airport Elevation : ","505."
"Departure ICAO region : ","LF"
"Departure Position : ","05"
"Destination Airport : ","LFML"
"Arrival Airport Elevation : ","74.02"
"Destination ICAO region : ","LF"
"Trip total Distance : ","369.27"
"Distance Remaining : ","216.64"
"Altitude Descent Target : ","22000"
"Descent Target distance : ","0."
"Current Flight settings : "
"Optimal Flight Level : ","410."
"FMS enabled : ","1."
"FMS init OK : ","1."
"FMS TakeOff Init OK :","0."
"Current flight phase :"
"Aircraft takeoff state","1.","0=Takeoff is not completed:SFCC in Ground mode 1=had takeoff:SFCC in flight mode"
"Takeoff phase","5."," -1=not cleared 0=Ready 1=takoff go 2=Aircraft is airborne 3=THR RED ALT reached 4=Initial acceleration 5=Aircrat is above 10000ft Takeoff is completed"
"Aircraft Climb","0."
"Aircraft Climb phase","3."," 0=aircraft is below 10000ft 1=Climb acceleration 2=Aircraft climb 3=Climb is completed 4=descent is engaged"
"Aircraft cruise","1."
"Aircraft descent","0."
"Aircraft Descent phase","0."," 1=initial descent engaged 2=aicraft is above conjunction altitude 3=aircraft is between Conjunction altitude and 18000ft 4=aircraft is below 18000ft"
"Aircraft Approach phase","0."
"Callout 80kts : ","1."
"Callout V1 : ","1."
"Callout Vr : ","1."
"Callout V2 : ","1."
"Callout Check Speed : ","0."
"FMS SETUP : "
"TakeOFF Page : "
"Runway Takeoff : ","05"
"Takeoff V1 Vr V2 : ","120.","134.","141."
"SRS Speed : ","156."
"GPS Nav Flag : ","1."
"Takeoff Runway Ok : ","1.","05"
"Cost Index Value : ","1.","40."
"Takeoff THUST mode 1=TOGA 2=FLEX : ","2."
"Flex To Temp setting : ","1.","32."
"Takeoff Flaps Config : ","3."," 0=clean 1=Slats1 2=1+F 3=1+2 4=3 4=full"
"Takeoff Heading : ","0.","49."
"LNAV Engage Altitude : ","1.","0."
"Thrust Reduction Altitude : ","1.","1200."
"Acceleration Altitude : ","1.","1200."
"Econ Thrust : ","1."
"EXPEDITE : ","0."
"N1 climb Thrust Below FL100 : ","1.","87.191"
"Climb Speed below FL100 : ","1.","250."
"Climb Speed Green Dot : ","0.","0."
"Constraint Altitude : ","1.","0."
"Constraint Speed : ","1.","0."
"QNH Transition : ","1.","5000."
"QNH State : ","1."," 0=barometric value 1=STD"
"CLIMB Page : "
"Climb Thrust ECON : ","1."
"N1 Climb Thrust above FL100 : ","1.","88.191"
"Climb Econ Thrust : ","1."
"Climb Thrust Expedite : ","0."
"ECON Flight Level : ","1."
"Flight Level 1 : ","1.","320."
"Climb speed IAS value above FL100 : ","1.","300."
"Climb Speed Econ : ","1."
"Conjunction IAS/MACH Altitude : ","1.","29000"
"Climb Speed MACH Value above Conjunction Alt : ","1.","0.78"
"Climb Speed MACH Econ : ","1."
"CRUISE Page : "
"Cruise ECON Speed IAS : ","0."
"Cruise Speed IAS FL1 : ","0.","0."
"Cruise ECON Speed MACH : ","1."
"Cruise Speed MACH FL1 : ","1.","0.78"
"Change Flight Level : ","0."
"Flight Level 2 : ","0.","0."
"Weight Flight Level 2 Kg and Pounds : ","0.","0.","0."
"Cruise Speed FL 2 Mach : ","0.","0."
"Top Of Descent : ","1.","140.05"
"Descent Constraint : ","0."
"FCU Settings : Knob FCU 0=selected mode 1=managed mode "
"SPEED : ","1."
"HDG : ","1."
"ALT : ","1."
"Altitude Constraint : ","0."
"Autopilot Pitch mode : ","0."
"V/S mode : ","1."," 0=Selected 1=managed"
"Speed Managed IAS : ","289."
"Speed Managed Mach : ","78."
"Aicraft is Above Transition : ","1."
"user FCU altitude Flag : ","0."
"ILS Land Phase : ","0."
"ILS Mode Armed : ","0."
"Approach Mode Armed : ","0."
"Localizer Armed : ","0."
"Approach type : ","0."
"Landing : ","0."
"Flare : ","0."
"Roll Out : ","0."
"Number of Waypoints : ","17."
"Offset waypoint list : ","0."
"Engine 1 Generator : ","1."
"Engine 2 Generator : ","1."
"DC Volts Selector : ","0."
"Inertial Sys on/off (0=enabled 1=Disabled) : ","0."
"Inertial Data (0=Localization 1=Wind and speed): ","0."
"Panel Cabin Light : ","1."
"Engine 1 Bleed 0=Open 1=closed: ","0."
"Engine 2 Bleed 0=Open 1=closed: ","0."
"APU Bleed : ","0."
"VOR Switch 1 : ","1."
"VOR Switch 2 : ","1."
"Index of Active Waypoint : ","11."
"Checklist ID : ","12."
"Aircraft is above Mach Altitude MACH mode is engaged : ","1."
"Speed/MACH button pushed : ","0."
"User specific landing frequency : ","0."
"FSX landing frequency : ","0."
"SFCC flag Flaps on ground : ","0."
"SFCC : Aircraft is airborne : ","1."
"SFCC Flaps config before takeoff : Aircraft is on ground : ","0."
"Zero Fuel Weight ZFW : ","48106"
"No Smoking Switch State : ","1."
"Seat Belt Switch State : ","1."
"Engine 1 Fuel burned since departure in Pounds : ","2051."
"Engine 2 Fuel burned since departure in Pounds : ","2061.5"
"Index first approach waypoint if Go Around : ","0."
"Altitude first approach waypoint if Go Around : ","0."
"Speed first approach waypoint if Go Around : ","0."
"Autopilot engaged : ","1."
"AutoThrottle engaged : ","1."
"Autopilot Hold Altitude : ","32000"
"Autopilot Altitude Lock : ","1."
"Autopilot heading value : ","49."
"Autopilot Heading Lock : ","0."
"Autopilot GPS Drives NAV1 : ","1."
"Autopilot Nav Lock : ","1."
"Autopilot AirSpeed Hold mode : ","0."
"Autopilot Mach Hold mode : ","1."
"FPA mode engaged : ","0."
"FPA Value in degrees : ","0."
"Final Approach Altitude unlocked : ","0."
"User descent Altitude Target Flag","0."
"User descent Altitude Target value","3074."
"User Descent Altitude Target Ok","0."
"Arrival Altitude without STAR","3100."
"Hydraulic Green","1."
"Hydraulic Yellow","1."
"Hydraulic Blue","1."
"Fuel On Board at Departure in Pounds","27437"
"Aircraft is changing FL Cruise ","0."
"Approach Gradient User Value","-3."
"ILS or LOC Backcourse Hold mode","0."
"Initial acceleration completed","1."
"Approach Auto Barometric Altimeter","0."
"Speed Constraint end Of STAR","230."
"Reserved","Not used on this version"
"Reserved","Not used on this version"
"Reserved","Not used on this version"
"Reserved","Not used on this version"
"Reserved","Not used on this version"
"SID Loaded : ","1."
"SID data : "
"05"
"EPIKO 7J"
"49."
"0."
"1200."
"1200."
"7000."
"5."
"205."
"9."
"1.","N","LF",,"SE","0.","0."
"2.","U",,,"SE10A","48.605","7.7229"
"3.","U",,,"SE10B","48.617","7.7055"
"4.","U",,,"SE10C","48.613","7.6814"
"5.","U",,,"SE10E","48.593","7.638"
"6.","W","LF",,"DOBEG","0.","0."
"7.","W","LF",,"DIBOT","0.","0."
"8.","W","LF",,"SOREM","0.","0."
"9.","W","LF",,"EPIKO","0.","0."
"STAR Loaded : ","1."
"STAR data : "
"32L-32R"
"BALSI 8C DOLIV"
"ILS32R-LOC32R-NDB32R"
"5."
"1.","W","LF",,"BALSI",,,,"22000",,"0",,,,
"2.","U",,,"MT440","45.114905","5.44278","29000","20000",,"0",,,,
"3.","W","LF",,"KURIR",,,,"18000",,"0",,,,
"4.","W","LF",,"SAURG",,,,"14000",,"0",,,,
"5.","W","LF",,"DOLIV",,,"14000","11000",,"1","1","161","341","80"
"Waypoint has an Holding pattern : ","0."
"Holding Pattern Armed or engaged : ","0."
"Hold pattern is running : ","0."
"Index WPT STAR holding pattern : ","0."
"WPT STAR holding pattern completed : ","0."
"Turn Direction 0=No current turn 1=Left 2=Right : ","0."
"Initial Heading : ","0."
"Opposite leg : ","0."
"Hold Pattern timing : ","0."
"Hold Pattern position : -1=initialisation 0=first turn 1=opposite leg 2=turn back 3=come back init WPT : ","0."
"Waypoint has an DME ARC : ","0."
"Waypoint has a leg turn back (teardrop turn) : ","0."
"Approach Loaded : ","0."
"Approach Data : "
"FSX Variables monitoring Values : "
"AUTOPILOT CONFIGURATION"
"Autopilot Armed","1."
"Auto Throttle Armed","1."
"Autopilot AirSpeed Hold mode","0."
"Autopilot Airspeed KIAS Value","289."
"Autopilot Mach Hold mode","1."
"Autopilot Mach Value","0.78"
"Autopilot Heading lock mode","0."
"Autopilot Heading Dir value","49."
"Autopilot NAV1 Lock","1."
"GPS Drives NAV1","1."
"Autopilot Altitude Hold","1."
"Autopilot Target Altitude","32000"
"Autopilot Vertical Speed ft/mn","0."
"Aircraft performances and environment"
"indicated Airspeed","288.08"
"Indicated MACH","0.77955"
"indicated Altitude","32000"
"Vertical Speed Ft/mn","-12.627"
"Throttle 1 percent","82.919"
"Throttle 2 percent","82.919"
"Throttle 1 notch","1."," -1=Reverse 0=IDLE 1=CL 2=FLEX/MCT 3=TOGA"
"Throttle 2 notch","1."," -1=Reverse 0=IDLE 1=CL 2=FLEX/MCT 3=TOGA"
"Total Weight in Kgs","58686"
"Fuel on Board in Kgs","10580"
"Flaps Position","0."
"Spoilers Armed","0."
"Ambient Wind Velocity","7.9788"
"Ambient Wind Direction","217."
"Ambient temperature in Celsius","-56."
"A32x series (Project Airbus A318-A319-A320-A321) FD-FMC Version 1.55 December 2016 - CSV file format can be read with EXCEL or similar software"
"© Francois Dore - September 2016 - Send me this file if you have bugs"
"LoggerX.dll Module © Robbie McElrath - LoggerX can be included in XMLTools.dll © Tom Aguilo"
"LoggerX Version : ","2."