Project Airbus – Talk

i'm having a major problem with project airbus a321, it seem's to start the flight and bounce everywhere and now ive changed the contact points its vibrating on the ground now, and when it goes up into the air its like turbulence. can you please help.

You modified the contact points....well, dunno how one could help you with that now

GaryG wrote:You modified the contact points....well, dunno how one could help you with that now

well ive swapped it from ifdg a321 and it's like turbulence in the air but ive only done it to one model and thats monarch, but i just put it on incase someone could help

ohh thank-you i hope it works

no it does'nt work i give in i was looking so forward..

Did you put the original contact points back before you tried?

What did you do to modify it? It doesnt do that when it comes 'straight from the box' so to speak. You must have modified something, or its the panel you are using.

Bill

ive only changed contact points and ive put them back they way they came and i though i'd try the weight was blank but i'll try a different cockpit.

Steve wrote:Did you put the original contact points back before you tried?

yes i did but it's not working still

I am experiencing exactly the same problem. Whenever I select the A321 the aircaft appears to be approximately 1/2 meter below ground (wheels sunk in the tarmac). It then bounces approximately 2 meters into the air then drops back to the ground whereby it crashes and the sim resets to repeat the whole scenario again. I have not amended any of the aircraft config file - this is the original. I have tried to load the aircraft with different weights (fuel and cargo etc) but that makes no difference. Any help would be appreciated.

Ken Brattey

I guess no one reads these request for support.

Have you tried downloading and installing a new A321?

I have downloaded the officail PAirbus models and used the installer program - what difference would it make to install a new one?