Hi,
im using a merge, AirbusX VC with your exterior A319 model. The problem is that the VC has lower position as it should have relative to the extrior, this is because of the different 0-Position Project Airbus and Aerosoft use.
Now i tried to move the PA A319 with ModelconverterX but after exporting the model was messed up.
My question now: Can you guys please provide an PA A319 mdl (A319_100_CFM_NoVC.mdl) that is moved 1,1 units down? That was the value i used in MCX and it lines the x axis (z-layer) with the center of the windshield.
It would be a nice move by you guys.
Regards
Max
Merging AirbusX with exterior PA A319, VC to low possion
Forum rules
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Please read the pinned topics and search the forum before posting to make sure your question's not already been answered.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Please read the pinned topics and search the forum before posting to make sure your question's not already been answered.
Re: Merging AirbusX with exterior PA A319, VC to low possion
99.9999% it won't be done, the reason I think is fairly obvious.
Regards
Regards
Re: Merging AirbusX with exterior PA A319, VC to low possion
I understand that it is work that needs to be done, but thats the only reason i could think about.
Realy no chance?
Realy no chance?
-
- Posts: 236
- Joined: 02 Jul 2009, 16:13
Re: Merging AirbusX with exterior PA A319, VC to low possion
Couldn't you just move the eyepoint in the aircraft.cfg to match the one used by aerosoft?
Re: Merging AirbusX with exterior PA A319, VC to low possion
Allready did that, but cause the VC is possitioned via the 0-Position of the the two models (exterior and VC). It is still 2 Feet (or so) to low. I noticed that when i looked out of the window next to a finger gate and the finger was way higher relative to the cockpit window when looking from the VC to the outside, then viewing it from the outside-view.
I asked at fsdeveloper about that and they told me the same: http://fsdeveloper.com/forum/showthread.php?t=63505
I asked at fsdeveloper about that and they told me the same: http://fsdeveloper.com/forum/showthread.php?t=63505
-
- Posts: 122
- Joined: 04 Dec 2010, 13:36
Re: Merging AirbusX with exterior PA A319, VC to low possion
Its not the eyepoint. It the model itself.
-
- Posts: 236
- Joined: 02 Jul 2009, 16:13
Re: Merging AirbusX with exterior PA A319, VC to low possion
Yeah there's no fix then, sorry.
Re: Merging AirbusX with exterior PA A319, VC to low possion
There would be one
But its ok! You dont want to do it, of course you dont have to do it
Thy anyway for responding.
But its ok! You dont want to do it, of course you dont have to do it
Thy anyway for responding.