FSX 318-319-320 Cargo doors command

[fabiosko]

Hi all,
with the new FSX models I cannot operate cargo doors anymore... which is the right command for them?
Tia

Fabio

[sknepper]

Hello Fabio,

As far as I know the command for opening the cargo doors on all the models is the [Shift]+[E] then [2]. Or if you want all doors to open you can do [Shift]+[E] then [1],[2],[3],[4] quickly in succession .

Good luck and hopefully you can unload your cargo.

[esg]

Cargo doors open with Tail hook on the FS9 models, should be the same

[fabiosko]

I tried both "Tail hook" and "Wing Fold" but they do not work in FSX...
Is there anybody who can open cargo doors is FSX? How?
Thanks

Fabio

[Steve]

Win 7 FSX sp2 here and all work just fine using shift E+1,2 etc

[fabiosko]

I have it merged with Wilco Airbus but I suppose doors are inside PA model, isn't it?
Anyway they do not work at all with my Win7 FSX sp2 and new model downloaded from AVSIM.
So sad...

Fabio

[esg]

Assuming they work with Tail hook you need to have the following in your Aircraft.cfg:

Code: Select all

[tailhook]
tailhook_length=1
tailhook_position=0,0,0

[fabiosko]

thanks for your help but it did not work! I inserted "tailhook" and also "wing fold" section in my aircraft.cfg but noway to open cargo doors
I change my sys to win7 from xp last week and since then the cargo doors are not working anymore... i think there should be somethingelse...
In XP they were working also without these sections. maybe developers could say something...
thanks

fabio

[esg]

And I assume you followed the instructions that came with the model and added the [Exits] section to the Aircraft.cfg and they still don't work with Shift+E+1/2/3/4?

Code: Select all

[Exits]
number_of_exits=4
exit_rate.0=0.19
exit_rate.1=0.02
exit_rate.2=0.19
exit_rate.3=0.17

maybe developers could say something...

The FSX models were compiled by Thomas Ruth, we had very little involvement.

[fabiosko]

And I assume you followed the instructions that came with the model and added the [Exits] section to the Aircraft.cfg and they still don't work with Shift+E+1/2/3/4?

Code: Select all

[Exits]
number_of_exits=4
exit_rate.0=0.19
exit_rate.1=0.02
exit_rate.2=0.19
exit_rate.3=0.17

maybe developers could say something...

The FSX models were compiled by Thomas Ruth, we had very little involvement.

of course i followed the included instruction putting in also the code for the exit...
if you any news I am here. thanks

fabio