Forum rules
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Community-driven support for Project Airbus aircraft only.
Please read the pinned topics and search the forum before posting to make sure your question's not already been answered.
-
ErrorInside
- Posts: 2
- Joined: 29 May 2011, 14:53
Post
by ErrorInside » 29 May 2011, 15:11
Hey everybody,
i have a little problem with my merged VC as you can see on the pictures below the VC lies way to far in the back of the AC (look at the position of the Gate-finger)
I guess there something wrong with my contact points.
Any help would be much appreciated.
Cheerio
Florian
-
esg
- Posts: 1584
- Joined: 01 Jul 2009, 22:03
Post
by esg » 29 May 2011, 15:20
Nothing wrong with the contact points, it's just that it's placed in the model where the A320's cockpit would've been (distance measured from the centre of the aircraft)
-
ErrorInside
- Posts: 2
- Joined: 29 May 2011, 14:53
Post
by ErrorInside » 29 May 2011, 15:22
So, thanks for the fast answer but is there a way to correct that??
Cheerio
Florian
-
esg
- Posts: 1584
- Joined: 01 Jul 2009, 22:03
Post
by esg » 29 May 2011, 15:32
Not to my knowledge
-
A321flyer
- Posts: 152
- Joined: 04 Feb 2010, 02:45
Post
by A321flyer » 30 May 2011, 23:07
first off, is that the project airbus A321 model? and the wilco A321 vc model merged with it? if so, you just made the best merge, how on earth did you do that?
